10 Steps to Installing a Sump Pump

Having a sump pump in your home can serve many purposes. The most important purpose is protection against flood. Anyone who lives near a river or in a town that is susceptible to flooding should really consider getting a one a sump pump for their basement. Also, anyone who has stores valuables in their basement should also consider getting one of these powerful devices. While it is not highly recommended to install you own device, here is a ten simple steps for those who are interested in trying to install one on their own.

10 Steps to Installing a Sump Pump

Find where the water will collect: While many choose to find a spot near a ground fault interrupter outlet, it is better to find a spot where the flooding may occur. Once you find this location it is best to install one of these outlets if there isn’t one already or have someone with some electric experience install it for you.

Dig your hole: Make sure to measure how big your sump it before digging your hole, because this will give you the information that you need for your sump size. Measure your sump and then build your hole 6 inches deeper and 10 inches wider than the size of your sump. After digging this hole, you should put approximately 3 inches of gravel into the hole, before placing the sump inside of the hole.

Stand in the Sump: Standing in the Sump will compact it into the ground as you pour gravel around the sump. If you do not stand in the sump many times it will shift and become off center. Leave an inch of the sump exposed at the top with gravel filling in the rest of the sump.

Add Adapters: Glue the male adapter into the discharge pipe, after doing this you can place the female adapter onto the pump. Now get your drill and make a ? inch hole that is 6 inches above the pump.

Add your Check Valve: Using wire ties attach the pumps electrical cord to the discharge pipe. Make sure to add the check valve on the open end of the discharge pipe. After completing this you are reading to check the pump and discharge water. Put the pump inside the sump and prepare for discharge of water.

Create a channel for water: Using 1 ? inch PVC piping create a tube for water to be discharged out of the house.

Create a hole for your pipe: Using a hammer or another utensil creates a hole just large enough for the PVC pipe to go outside of your home. Be careful to allow for the pipe to come at least 5 feet outside of the house and to be aimed at land that slopes away from the house.

Seal up the hole: Make sure to seal the hole you created with a waterproof sealant such as silicone. Once you complete the sealant allow time to dry before testing anything else.

Create a mouth at the end of the pipe: Apply an increase with a wide circumference, usually 3 or more inches to the end of your outside pipe. This allows water to flow out faster and spread throughout your yard, avoiding any major puddles.

Cover up your sump: Place gravel around the corrugated pipe to make it stay in place and add your cover to the pump.

Is your house ready for a flood? If not you may be interested in information on finding a hydromatic sump pump [http://www.hydromaticsumppump.net] for your basement. For more valuable information on hydromatic sump pumps please visit http://hydromaticsumppump.net [http://www.hydromaticsumppump.net].